Precision-trading PM5200 Manuel d'utilisateur télécharger pdf (Page 10)

Blender

Air-Oxygen

COMPONENT DESCRIPTION

ITEM DESCRIPTION

F Air Inlet Fitting

A male DISS or NIST air ﬁtting with one way valve

that is used to connect an air supply hose.

G Alarm

An audible alarm that sounds due to an excessive

pressure drop or deletion of either gas supply.

H Manifold Outlet (Optional)

Manifold with 3 primary outlets.

I Rear Slide Mount with dove tail.

INSTALLATION

WARNING

Read this User Manual before installing or operating the

Air-Oxygen Blender.

Conﬁrm the concentration of air/oxygen with an Oxygen

Analyzer/Monitor.

•

1. Secure the Air-Oxygen Blender to a wall or pole bracket in an

upright position.

2. It is recommended to install a condensation trap in the air

supply line.

3. Connect the air and oxygen supply lines to the appropriate

inlet ﬁttings on the bottom of the Blender.

4. Attach a ﬂowmeter, or other metering device to one of the

outlet ports.

Primary Outlets Flow capacity:

• High Flow Blender (PM 5200 Model) 15 lpm to 120 lpm

• Low Flow Blender (PM 5300 Model) 3 lpm to 30 lpm

Auxiliary Outlet:

This will bleed off some of the air/oxygen mixture to

maintain concentration accuracy at the Low Flow setting.

• High Flow Blender (PM 5200 Model) 15 lpm or less

• Low Flow Blender (PM 5300 Model) 3 lpm or less

5. Attach a supply line to the outlet port of the ﬂowmeter.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

Pas de commentaire

Precision-trading PM5200 Manuel d'utilisateur Page 10